Manual Release Car Park Entrance Barriers Automatic Boom Barrier 1400rmp DZTP-133-A manufacturer from China Shenzhen Wonsun Machinery Electrical Technology Co. Ltd

Manual Release Car Park Entrance Barriers Automatic Boom Barrier 1400rmp

Place of Origin:

Zhejiang, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

Model No.: DZTP-133-A

Manual Release 220v Gate Barrier Car Park Barriers Parking System Barrier

Features

Manual Release 220v Gate Barrier Car Park Barriers Parking System Barrier

Features

1) The humanized clutch device:in case of power off, unlock the clutch device and raise the boom manufally. By the time the power is supplied, lick the clutch device to make it working normally again.

2) Special spring device:Both the compression spring and tension spring can be used in the machine, Using the compression sprin can avoid accidents caused by the tension spring.

3) Three control buttons:for boom raising, falling and pausing.

4) Boom backtrack function:the boom will rise if hits something when falling.

5) Infrared photocell design:for avoiding the crash when the boom falling, so as to prevent the vehicles from being pressed.

6) Both external and internal loop detectors are supported.

7) "open","close" and "stop" controlling interfaces.

8) RS-485 communication serial interface(optional)

9) Traffic light signal connection device: red light for stop,green light for pass.

10) Remote control and wire control for selection.

1 pcs Gate Barrier
1 pcs arm boom (from 1m to 6m can customised)
1 pcs control panel(built inside)
2 pcs remote controllers
1 pcs manual book

Specifications

Model	WST1211
Working Temperature	-40+75
Voltage	220V±10%, 110V±10%, 50/60HZ
Rated power	80W
Relative humidity	≤90%
Remote control distance	≥30m
Net weight	48kgs
Speed	1S,1.8S,3S, 6S
Max boom length	6 meters
Motor Rotational speed	1400rmp
Protection Degree	IP44

Communication with customers

1) Q: Connected power and press open/close button but traffic barrier gate no action?

A	Reason	Solution
1	Fuse blown	Check fuse and power in controller
2	Battery of remote control powered off	Change a new one
3	External protection circuit break or at protecting status	Open the barrier door and click OPEN/CLOSE button on control box
4	Same frequency interference	Check photocell and loop detector

2) Q:Connected power and press open/close button,traffic barrier gate will move but even when it is at right position, the motor still running and not stop?

Reason

Solution

Limit switch

Adjust the horizontal/vertical limit switch to correct position<